OKX review

List of catalogs in this article:

• 1,OKX review What is the best way to debug the car audio?
• 2, How to debug the car clutch if it is too low?
• 3, What does a car debugger do

What is the best way to debug the car audio?

1. The best way to adjust the car audio: the frequency of the bass band should be adjusted in the range of 60HZ to 250HZ, so that the sound effect will be relaxed and not too high or too low. SECONDLY, THE FREQUENCY OF THE MIDDLE SOUND SEQUENCY IS FROM 1KHZ TO 4KHZ range adjustment, the sound effect within this range will be very clear, and the experience is very good.

2. The best ways to adjust the car sound effect include host debugging, front sound field debugging, rear sound field tuning, etc.

3. For the equalizer, the general adjustment method: 1 grid of treble gain, 2 grids of midrange gain, 2 grids of bass attenuation, so that the car audio can achieve the best effect.

How to debug the car clutch if it is too low?

1. The mechanical clutch can be adjusted by adjusting the loosening of the clutch wire, or by changing the length of the clutch wire. Among them, the former method can be fine-tuned, the latter method has a wide range of adjustments, while the latter method already belongs to the category of transformation. If the adjustment is not timely, it will affect driving safety, so this operation is not recommended.

2. Method: turn off the ignition, pull the handbrake, idle gear. The person lay on the driver's feet and found something soft to cushion it. It was very painful.

3. Hydraulic clutch adjustment method: The part connecting the clutch master pump and the clutch pedal can be adjusted if there is a thread, and the adjustment direction is the counterclockwise rotation screw. If there is no adjustment screw, the clutch height can only be changed by changing the length of the clutch sub-pump putter.

What does the car debugger do

1. The main work of the test driver is as follows: prepare for inspection, and carry out detailed vehicle inspection at the beginning of each test and handover, including Including security inspection and operation inspection. We also need to carry out a detailed inspection of the appearance of the vehicle.

2. Automobile debugger, which is a professional and mysterious profession. They are not only testers and even excellent engineers, but also often walk to the extreme edge of the vehicle and have no fear of speed. They are not drivers, but always put the safety of the car first.

3. The work content of the computer debugger is to carry out computer assembly and fault.Exclusion and hardware maintenance, and allocation to run the computer, that is, the operation skills of "saccuring" the computer and repairing the computer 1 Installation and debugging of the computer system 2 CMOS parameter settings 3 The use of diagnostic maintenance tool software 4 Config file and autoexec.

4. The work content of B2 debuggers usually includes troubleshooting and troubleshooting of cars, maintenance, adjustment and testing of cars, etc.

5. The test driver of the automobile factory is specifically responsible for the implementation of the test plan, the implementation of each test action and requirements according to the test specifications and the data recording, the wiring and disassembly of various sensors of the test vehicle, and the maintenance and custody of test instruments and equipment.

6. Hello. The installation you asked about should mean installation and debugging.Automobile industry: There is an overall shortage of talents. In the next five years, according to the level and needs of automobile development, the contradiction between the supply and demand of talents will not increase gradually, but will surge.